Ask Our Pros Bulletin Board - Home Remodeling & Repair ~ How To Projects ~ Toxic Black Mold Solutions ~ We Buy Homes ~ Home Improvement & Repair Contractors ~ Kitchen & Bath Remodeling ~ Home Contractors ~ Prescreened Contractors ~ Bathroom Remodeling and Bathtub, tile and countertop refinishing ~ sell my home ~ we buy ugly homes ~ home improvement ideas ~ remodeling ideas ~ black mold test kits ~ mold remover ~ avoid or stop home foreclosure ~ mold inspectors ~ mold remediation, abatement & remediators

You are not logged in. [Log In] Home » Forums » Ask Our Pros » Home Improvement & Repair
» pedestal sinks

Page 1 of 1

Topic Options

Rate This Topic

#1514 - 12/20/05 03:22 PM pedestal sinks
remington remington Do It Yourselfer Registered: 12/20/05 Posts: 1 Loc: Pennsylvania	I'm installing a pedestal sink. The precut holes do not match up with the plumbing coming through the wall. I need to cut a section out of the pedestal sink. What would be the best tool to use. I thought about using a rotozip tool with a ceramic cutting bit, Will this work?
Top

#1515 - 12/29/05 01:16 PM Re: pedestal sinks
provip provip Super Do It Yourselfer Registered: 03/03/01 Posts: 1153 Loc: Victoria, BC, Canada	I would want to know what the sink is made out of. Is it synthetic, porcelin, fiberglass, marble, granite, etc.. Some materials are easier to work with. I can imagine the zip tool working ok as long as you can determine you are not cutting any re-enforcement inside. ------------------ Bart Blainey, B.E.R. Consultant/Journeyman Carpenter Building Envelope Specialist Master Renovator provip@prodeck.org http://www.prodeck.org Barton Blainey (provip) specifically assumes no legal liability or responsibility for the accuracy, completeness or usefulness of any information or process disclosed. The above further expressly advises that any use of or reliance upon the information and or opinion disclosed is at your risk . _________________________ Bart Blainey, B.E.R. Consultant/Journeyman Carpenter Building Envelope Specialist Master Renovator provip@prodeck.org http://www.prodeck.org Barton Blainey (provip) specifically assumes no legal liability or responsibility for the accuracy, completeness or usefulness of any information or process disclosed. The above further expressly advises that any use of or reliance upon the information and or opinion disclosed is at your risk .
Top

Page 1 of 1

Previous Topic View All Topics

Moderator: RemodelingGuy, provip

Hop to:

Generated in 0.031 seconds in which 0.013 seconds were spent on a total of 12 queries. Zlib compression enabled.