Black Mold Education ~ Home Improvement & Repair Projects & Articles ~ Do It Yourself Home Repair ~ Toxic Black Mold ~  How to Kill Toxic Black Mold ~ Mortgage Refinance ~ Contractors ~ We Buy Homes ~ Refinancing ~ We Buy Homes ~ Prescreened Contractors

- -

Home │ Blog │ Store │ Contact
Remodeling Solutions--
 Interior Home Improvement
Exterior Home Improvement
Everything Woodworking
Tub & Tile Refinishing Pages
Black Mold Solutions
 --
 D.I.Y. Black Mold Clean Up
Toxic Black Mold Education
Toxic Black Mold Solutions
Find Up To 4 Local & Screened Contractors
---
 Remodeling Contractors
 Home Repair & Svc. Pros
 Landscaping & Deck Pros
 Patio & Paver Contractors
Kill Mold - Find Local Toxic Black Mold Pros
---
 Black Mold Inspectors
 Mold Removal Contractors
Sell Us Your Home
 Avoid Home Foreclosure
 Stop Home Foreclosure
-

--
 Refinance Quotes
 Green Home Section
 Storm & Weather Pages
 Visit Our Black Mold Site at
 ToxicMoldUSA.com
 Built Rite Web Awards
 Home Related Links
 Advertise with Us
 Recent Press / Media
 Want to Contact Us?  
 Ask Our Home Pros
 Job Opportunities
 Our Privacy Statement
 Our Site Disclaimer
 Site Map
-

Last Updated
08/02/10 08:45 AM

-

Toxic Black Mold Pictures - Pictures of Stachybotrys
DIY Toxic Black Mold CLEAN UP Pictures
 --
REMEDIATION / BLACK MOLD CLEAN UP


It may be necessary to remove electrical and
plumbing to sand down an area properly. Do what it
takes to do the job RIGHT! No Short-cuts.


Spraying biocide doesn't require 6 hands :), but
make sure that you spray in, around and behind
everything, including up into the wall cavity.


Some problems may be easier to attack from the
exterior.  This is a corner bath requiring the
contractor to replace the rotten corner posts.
A 2nd story tub mold infestation required the floor
to be replaced and reinforced. New wood in the
walls and several new studs was needed.

Once the black mold has been cleaned from the
structure, it's time to address the Indoor Air Quality.
Dehumidifiers control moisture.
If you have a high relative humidity in a room or
area (55% or higher), then you should strongly
consider a dehumidifier.

Negative air machines are turned on and vented
to atmosphere during tear out and mold remediation
to control dust and air-born mold.
Once the job is ready for final clearance, the
negative air machines run continuously to scrub
the air with 2 or 3 stage Hepa / Allergen filters.